How To Turn Off Gas Fireplace Pilot Light. Depending on the model of your fireplace, hold the lever slightly before turning the dial. These are some basic steps no matter the make, model, or year of your fireplace.
These are some basic steps no matter the make, model, or year of your fireplace. Make sure before doing so that the pilot light has been on for at least two minutes or longer—then switch off the pilot light. Gas fireplace shuts off, and pilot goes out
Table of Contents
Simply Place The Knob On The Off Position, And It Should Do The Trick.
To turn off your fireplace’s pilot light, you need to follow the steps below: You would think that turning off the pilot light is as easy as turning the knob to the ‘off’ position. This action will start the gas flow into the fireplace logs.
The Flame May Be Located In The Back Or Behind Some Of Your Logs.
Unless the gas is physically turned off, the pilot light will be on. Turn on the supply line to the gas fireplace. Turn your gas valve control knob to “pilot.” do not force pilot light controls or use oil if they are sticky.
Unless The Gas Is Physically Turned Off, The Pilot Light Will Be On.
Once the dial is turned off, the gas supply will shut off for your furnace and cause the pilot light to turn off. To make sure the key is in the right position, you can jingle it a little until the lock slid into its place in the keyhole. Millivolts that close and open your gas valve.
Pilot Light Systems Are The Most Common Reason Gas Fireplaces Fail To Light, So Check The Main Gas Valve To Make Sure The Gas Is Turned On.if Gas Is Coming Out Of The Pilot, But It Still Won't Light, The Spark Igniter Could Be The Problem.look For And Clear Out Any Debris Between The Igniter And Thermocouple.
How to light pilot light on gas fireplace insert. Open the control box of the fireplace and locate the pilot switch. You’ll locate the main gas control valve, then the thermopile sensor which should have its electric contacts labeled (th/tp and tp) on the valve itself.
The Gas Supply Should Also Be Isolated By Turning The Gas Valve Located Near To Or Within The Fireplace To The Off Position.
When the two of the above method fails, you have to go a bit deep into the control system. Press your pilot light button while holding a flame to the pilot burner. Turn the knob from the “off” to the “pilot” position.